USB-UART Adapter

From Techno-Innov's Wiki
Jump to navigation Jump to search

Description

The USB-UART adapter is pretty simple but usefull and ressourcefull. It provides access to a serial link (3.3V UART) from an USB port, either USB male or micro-USB female which is one of the cool special features of this adapter. Another cool feature is the 3.3V and 5V power both available on 2.54mm headers, usefull for most prototyping needs.

This adapter uses an FTDI FT230XS, with most signals available on the UEXT-like connector, and should thus support I2C, SPI, and other protocols or data busses using the bitbanging capabilities of the FTDI chips, though this would require software support on your side as we did not have time to do so yet (We'll keep you up-to-date as soon as we have more information on these).

How-to use

Connectors

P1 Connector

File:USB UART V02 P1.png

P1 connector is a standard 2.54mm (0.1 inch) pitch header, with 2 row of 5 pins.

P1 connector
Pin # Description FT230XS signal Note
1 +3.3V from FT230XS +3.3V Out --
2 GND - Ground -- --
3 UART Tx TxD FT230XS pin 1
4 UART Rx RxD FT230XS pin 4
5 I2C SCL RTS FT230XS pin 2
6 I2C SDA CTS FT230XS pin 6
7 SPI MISO Sleep FT230XS pin 16
8 SPI MOSI TxDEN FT230XS pin 15
9 SPI CLK RxLed FT230XS pin 14
10 SPI CS Tx Led FT230XS pin 7

P2 Connector

File:USB UART V02 P2.png

P2 connector is a standard 2.54mm (0.1 inch) pitch header, with 1 row of 2 pins, which provides access to 5V power from USB.
Note : Be careful, never connect them together as if they were for a jumper config, it would short-circuit the USB power and burn the ferite bread on the board.

P2 connector
Pin # Description Note
1 +5V +5V from USB
2 GND Ground

P3 : micro USB debug connector

P3 is a female USB microB port.
Refer to the Universal Serial Bus (USB) page on Wikipedia for pinout and more information on the USB bus and connectors.

P4 : USB type A debug connector

P4 is a male USB type A port.
Refer to the Universal Serial Bus (USB) page on Wikipedia for pinout and more information on the USB bus and connectors.

TODO List

  • Technical documentation
  • I2C and SPI support using the bit-banging capabilities of the FTDI chip (Host side software support)
  • SWD and/or JTAG support
  • RS232 version
  • Low voltage (1.8V) version (microprocessors and SWD/JTAG debug support)

Technical Documentation and Schematics

The technical documentation has not been written yet ...

Version history

V0.1

First version.

  • 24mm x 30mm
  • Two USB connectors (USB type A male and micro-USB B female)
  • Two push buttons for ISP/Reset
  • 6 pins on P1 connector (standard 2.54mm (0.1 inch) pitch header, with 2 row of 3 pins).
P1 connector
Pin # Description FT230XS signal Note
1 +3.3V from FT230XS +3.3V Out --
2 GND - Ground -- --
3 UART Tx TxD --
4 UART Rx RxD --
5 Reset RTS Also connected to SW1 push button
6 ISP TxDEN Also connected to SW2 push button